Chapter 5 – Troubleshooting
Section 5.3 – Error Messages
5 - 11
Data Entry Message This occurs if: Service Light
The alphanumeric string is
too long to fit in the data
field. Additional
characters will not be
displayed.
There are too many characters in
an entry field. The entry field is
limited to 17 characters.
Off
The Set ID does not match
a required set code.
Touch ‘Edit’ to re-enter the
Set ID.
The illuminator was not
configured to use the selected
processing set. Ensure the
barcode data has been entered
in the correct order. If this
message continues to occur,
contact your authorized service
representative.
Off
The Set ID is obsolete.
Touch ‘Edit’ to re-enter the
Set ID.
The Set ID entered has been
disabled and is no longer
intended for use.
Off
The valid range for labels
is 0 – 6. Touch ‘Edit’ to
re-enter the number of
labels to print.
The number entered for labels to
be printed was greater than 6.
Off
The entered date is
invalid. Touch ‘Edit’ to
re-enter the date.
The date was not entered in the
correct format. You must enter
2 numbers each for the month
and day fields and 4 numbers for
the year field. See Section 3.7 for
details.
Off
The entered time is
invalid. Touch ‘Edit’ to
re-enter the time.
The time was not entered in the
correct format. You must enter
2 numbers each for the hour and
minute fields. See Section 3.7 for
details.
Off
The entered TCP/IP
address is invalid. Touch
‘Edit’ to re-enter the
address.
The TCP/IP address was not
entered in the correct format.
You must enter 12 characters for
the address. See Section 3.7 for
details.
Off
Format Error.
The data does not match
the selected format for
this field. Please press
‘Cancel’ to re-enter the
data.
The data entered into a field
does not match the selected
format. Upon canceling the pop-
up message, re-enter the data in
the correct format or press
‘Cancel’ to quit the treatment.
Off
To Next Page
Loading...