SECTION 5
PERFORMANCE
CESSNA
MODEL 208B (675 SHP)
CARGO POD INSTALLED
CRUISE PERFORMANCE
NOTES
The following general information is applicable to all Cruise
'.
Performance Charts contained in Figure 5-17, Sheet
2
through Sheet
13, in this section.
1. The highest torque shown for each temperature and RPM
corresponds to maximum allowable cruise power. Do not exceed
this torque, 740°C ITT, or 101.6%
Ng, whichever occurs first.
2. The lowest torque shown for each temperature and RPM
corresponds to the recommended torque setting for best range
in zero wind conditions.
3. With the inertial separator in BYPASS and power set below the
torque limit (1865 foot-pounds), decrease the maximum cruise
torque by 100 foot-pounds. Do not exceed 740°C ITT. Fuel flow
for a given torque setting will be 15 pph higher.
4. With the cabin heat on and power set below the torque limit
(1865 foot-pounds), decrease maximum cruise torque by 80
foot-pounds. Do not exceed 740°C ITT. Fuel Flow for a given
torque setting will be
7
pph higher.
Figure 5-17. Cruise Performance (Sheet 1 of 13)
Revision 23
To Next Page