CESSNA SECTION
8
MODEL 2088 (675 SHP)HANDLING, SERVICE, AND MAINTENANCE
DEICEIANTI-ICE
BOOT
CARE
The wing, wing strut and stabilizer deice boots are electrically
conductive through all
dies and the edge sealer to bleed off static
cnarges
whlch c&se radlo Interference and may perforate the boots
Fuellna and other servlclna oDerattons should be done carefully to
avoid damaging or tearing the boots.
To prolong the life of deice boots, they should be washed and
sewiced
on a regular basis. Keep the boots clean and free from oil, grease and
other solvents which cause rubber to swell and deteriorate. Outlined
below are recommended cleaning and servicing procedures.
CAUTION
USE ONLY THE FOLLOWING INSTRUCTIONS WHEN
CLEANING
BOOTS-DISREGARD
INSTRUCTIONS
WHICH RECOMMEND PETROLEUM BASE LIQUIDS
(MEK, NONLEADED GASOLINE, ETC.) WHICH CAN
HARM THE BOOT MATERIAL
1. Clean boots with mild soap and water, then rinse thoroughly with
clean water.
CAUTION
TEMPERATURE OF WATER FOR CLEANING
DE-ICE1
ANTI-ICE BOOTS SHALL NOT EXCEED 140°F.
NOTE
lsopropyl alcohol or toluene can be used to remove grime
which can not be removed using soap. If isopropyl alcohol
or toluene is used for cleaning, wash area with mild soap
and water, then rinse thoroughly with clean water.
=,
-,
-
?,
=,
=,
-.
='
1
Revision
23
=,
.-
(Continued Next Page)
U.S. 8-45
To Next Page
Loading...
