Cessna 208B - Page 480

6
SECTION 8 CESSNA
HANDLING, SERVICE, AND
MAINTENANCEMODEL 208B (675 SHP)
DEICEIANTI-ICE BOOT CARE (Continued)
2. Allow the boots to dry, then apply a coating of Age Master No. 1
to the boots in accordance with application instructions on the
container.
CAUTION
DO NOT APPLY AGE MASTER NO.
1 TO BOOTS
TREATED
WITH BFG RESURFACING KIT 74-451-L.
NOTE
Age Master No.
1 is beneficial for its ozone and weather
resistance features.
3. After the boots have been treated with Age Master No. 1, apply a
coating of ICEX
II to the boots in accordance with application
instructions on the ICEX
II container.
NOTE
ICEX
II may be beneficial as an ice adhesion depressant.
Both Age Master No. 1 and ICEX
II are distributed by the
BFGoodrich Company.
CAUTION
~ ~
PAINTING ALMOST IMPOSSIBLE
Age Master No. 1 and ICEX
II coatings last approximately 50 hours on
the wing and stabilizer de-ice boots and 150 hours on propeller anti-ice
boots.
Small tears and abrasions on pneumatic de-ice boots can be repaired
temporarily without removing the boots and the conductive edge sealer
can be renewed. Your Cessna
Service Station has the proper materials
and knowledge how to do this correctly.
Revision 23