Cessna 208B - Introduction

CESSNA SECTION 2
MODEL 2088
(675 SHP) LIMITATIONS
INTRODUCTION
Section 2 includes the operating limitations, instwment markings, and
basic placards necessary for the safe operation of the airplane, its
engine, standard systems and standard equipment.
WARNING
THE LIMITATIONS INCLUDED IN
THIS SECTION AND IN
SECTION
9 HAVE BEEN APPROVED BY THE FEDERAL
AVIATION ADMINISTRATION. OBSERVANCE OF
THESE OPERATING LIMITATIONS IS REQUIRED BY
FEDERAL AVIATION REGULATIONS.
NOTE
Operation in countries other than the United States may
require observance of other limitations, procedures or
performance data.
Refer to Section 9 of this Pilot's Operating Handbook for
amended operating limitations, procedures, performance
data and other necessary information for supplemental
systems.
I
The airspeeds listed in Figure 2-1, Airspeed Limitations
chart, and Figure 2-2, Airspeed Indicator Markings chart,
are based on Airspeed Calibration data shown in Section
5 with the normal static source. If the alternate static
source is being used, ample margins should be
observed to allow for the airspeed calibration variations
between the normal and alternate static sources as
shown in Section
5.
Your Cessna is certificated under FAA Type Certificate No. A37CE as
Cessna Model No.
2088.
FAA APPROVED
1 Revision 23 U.S. 2-3