-
SECTION 8 CESSNA
HANDLING, SERVICE, AND
MAINTENANCEMODEL 2088 (675 SHP)
FUEL (Continued)
-
PROCEDURE FOR ADDING FUEL ANTI-ICING ADDITIVE
-
When the airplane is being refueled, use the following procedure to
blend anti-icing additive to nontreated fuel:
.~
1.
Attach additive to refuel nozzle, making sure blender tube
discharges in the refueling stream.
2. Start refueling while simultaneously fully depressing and slipping
ring over trigger of blender.
WARNING
CAUTION
. DIETHYLENE GLYCOL MONOMETHYL ETHER
(DIEGME~ISSLIGHTLY
TOXIC
IF
SWALLOWED
AND
MAY CAUSE EYE REDNESS, SWELLING AND
IRRITATION. IT IS ALSO COMBUSTIBLE. BEFORE
USING
THIS
MATERIAL REFER TO ALL SAFETY
....
.-,
-~
~
~
INFORMATION ON THE CONTAINER.
CAUTION
ASSURE THE ADDITIVE IS DIRECTED INTO THE
FLOWING FUEL STREAM
WITH THE ADDITIVE FLOW
STARTED AFTER THE FUEL FLOW STARTS AND
STOPPED BEFORE FUEL FLOW STOPS. DO NOT
ALLOW CONCENTRATED ADDITIVE TO CONTACT
COATED INTERIOR OF FUEL TANK OR AIRPLANE
PAINTED SURFACE.
USE NOT LESS THAN 20 FLUID OUNCES OF
ADDITIVE PER 156 GALLONS OF FUEL OR MORE
THAN 20 FLUID OUNCES OF ADDITIVE PER 104
GALLONS OF FUEL.
(Continued Next Page)
Revision 23
To Next Page
Loading...
