Cessna 208B - Page 488

SECTION 8 CESSNA
HANDLING, SERVICE, AND
MAINTENANCEMODEL 2088 (675 SHP)
UMlb
ANNUNCIATOR PANEL LIGHTS
Push in on faced llght assembly and allow
assembly
to pop out. Pull assembly out to
limn of ns hinged retainet and allow n to
rotate 90 degrees down. Retainer will keep
light assembly suspended in this postion.
Lift defective buibout of assembly and
replace with
MS25237-327 bulb (MS25237-
8918 14-volt bulb in IGNITION ON light
assembly only). Rotate light assembly
upward into position and press into place.
NOTE:
Each light assembly mntains two
bulbs, and.
if necessary, remins
Sufficiently illumlnated wnh one
bulb defective.
POST LIGHTS
desired direction.
CONTROL WHEEL MAP LIGHT
Grasp rim of bulb, push straight up and
turn counterclockwise as far as
pssibie,
then pull bulb straight down and out of
socket. Replace with 24RB bulb. To install
new
bulb in sockat, align pinson bulb with
slots in socket, then push straight up and
rotate bulb clockwiseas far as possible.
Figure 8-6. Bulb Replacement
2681R1C48
Revision 23