ASXPRESS PLUS Rapid Sample Introduction System Operator’s Manual
Chapter 1: Introduction
14
Where to Go for More Information
In addition to this manual, you can refer to the following resources:
The ASXpress Plus Quick Installation Guide (In many cases, a version
specific to your autosampler will be included with the installation kit.)
The software manual for the ICP/ICP-MS instrument you are using
The operator’s manual for the autosampler you are using
The CETAC Technologies Web site: www.cetac.com
CETAC Technologies Customer Service and Support:
1 (800) 369-2822
1 (402) 733-2829
1 (402) 733-1932 (Fax)
E-mail:
custserv@cetac.com
Installation Overview
In most cases, a CETAC representative will assist with the installation of the
ASX
PRESS PLUS Rapid Sample Introduction System.
The following chapters describe how to install the ASX
PRESS PLUS Rapid Sample
Introduction System:
1 Select a location and unpack the ASXPRESS PLUS Rapid Sample Introduction
System. (Chapter 2, page 15)
2 Set up your autosampler.
This procedure depends on which autosampler and pump you are using.
3 Install the valve/pump module. (Chapter 6, page 67)
Connect tubing from the autosampler to the valve/pump module, then to
the nebulizer.
4 Install the electronics module. (Chapter 7, page 77)
Connect the electronics module to a power source and to the valve/pump
module, then set up the electronics module to intercept communications
between the ICP host computer and the autosampler.
5 Install the software. (Chapter 8, page 87)
6 Configure timing parameters. (Chapter 9, page 99)
7 Begin using the ASXPRESS PLUS Rapid Sample Introduction System. (Chapter 10,
page 107)
To Next Page
Loading...
