ASXPRESS PLUS Rapid Sample Introduction System Operator’s Manual
Chapter 14: Safety and Regulatory Information
150
Safety Notices
If the equipment is used in a manner not specified by CETAC Technologies,
the protection provided the equipment may be impaired.
Repair or service that this not covered in this manual should only be
performed by qualified personnel.
Power Cord Set Requirements
The power cord set supplied with your instrument meets the requirements of
the country where you purchased the instrument. Power is supplied to the
ASX
PRESS PLUS through the included 24v power supply.
Power Cord Safety Maintenance
The operator should check the power/signal supply cord condition. The
equipment should not be operated if the mains inlet is cracked or broken. Any
obvious damage to the case (from a drop or fall) should be checked by service
personnel for loose or damaged parts. See individual parts lists for approved
replacement parts
Mains Disconnect
Power mains disconnect is accomplished by unplugging the power cord at the
power supply or at the wall outlet. Ensure the power cord is easily accessible
and removable, in the event of an emergency which requires immediate
disconnection.
SHOCK HAZARD
Ensure that power cord is disconnected before removal of any covers.
WARNING
WARNING
To Next Page
Loading...
