CETAC ASXPRESS PLUS - Updating Firmware

ASXPRESS PLUS Rapid Sample Introduction System Operator’s Manual
Chapter 11: Maintaining the ASXpress Plus Rapid Sample Introduction System
126
Updating Firmware
You may need to update the firmware in the electronics module in order to use
the ASX
PRESS PLUS Rapid Sample Introduction System with a different
autosampler or to take advantage of new features.
A firmware update program and instructions (Upgrading Firmware for the
CETAC ASXPRESS PLUS Rapid Sample Introduction System) are installed along
with the Xpress Configuration Tool software, and are also provided with the
firmware update.
Updating the firmware involves opening the case of the electronics module. For
instructions, see Upgrading Firmware for the CETAC ASXPRESS PLUS Rapid
Sample Introduction System.