ASXPRESS PLUS Rapid Sample Introduction System Operator’s Manual
Chapter 2: Preparing for Installation
17
The valve/pump module receives power from the electronics module.
In case of hazard, the autosampler should be disconnected from the power
source as well as from the ASX
PRESS PLUS system.
Unpacking the ASXPRESS PLUS Rapid Sample
Introduction System
Inspect external packaging upon receipt for signs of shipping damage. Inspect
all items during unpacking and notify the carrier immediately of any concealed
damage. Check for kinked tubing in the sample loops or other tubing.
If the system is shipped or removed from storage during cold weather, allow
the packaged equipment to equilibrate to room temperature before opening
and exposing to warm, humid air. It is usually sufficient to provide four to eight
hours for this purpose.
If condensation forms on or inside the ASXPRESS PLUS Rapid Sample Introduction
System, allow it to dry thoroughly before connecting it to a power source and
operating it. Failure to do so may cause equipment damage.
Remove the packing checklist from the shipping container, and check off items
against it. Leave accessories in the packing until you are ready to install them.
NOTE
Keep the factory packaging for use in case the product ever needs to be
returned or shipped to another location.
CAUTION
To Next Page
Loading...
