8 Installing the
Software
The Xpress Configuration Tool software is used to enable/disable and
configure the autosampler and its control of the ASX
PRESS PLUS system, as well
as providing access to manual functions of the ASX
PRESS PLUS system and
autosampler. The ASX
PRESS PLUS system is controlled by the autosampler, which
executes a macro automatically when the probe is placed into the sample.
NOTE
The procedures given in this chapter are for use in a Windows
2000/XP/Vista/Windows 7 environment.
Installing the Xpress Configuration Tool
1 Load the Xpress Configuration Tool software onto the host computer from the
CD provided.
The software will autorun when the disc is loaded into the CD-ROM drive of
the host computer. If it does not, use Windows Explorer to open the drive
letter containing the disc, then select “Setup Launcher” (Figure 8-1) to begin
the software installation.
To Next Page
Loading...
