ASXPRESS PLUS Rapid Sample Introduction System Operator’s Manual
Chapter 9: Configuring the ASXpress Plus System
103
Additional Xpress Configuration Tool Features
Built-In Help
For general instructions, click the Help icon:
For help on an individual field, click the What's This help icon, then "hover" the
mouse over the field of interest:
Comm Port
Sets the USB or serial port used to communicate with the ASXPRESS PLUS system.
This port corresponds to the cable between the host PC and the GUI COM port
on the electronics module. See page 93 for more information.
Note that the port used to communicate with the autosampler is always
controlled through the ICP software , regardless of whether or not the ASX
PRESS
PLUS system is used.
Change Personality
To configure the ASXPRESS PLUS system to work with a particular autosampler
model, select Change Personality from the Tools menu. See page 95 for more
information.
Notes Window
You can display a very simple note-taking window alongside the Xpress
Configuration Tool.
To Next Page
Loading...
