ASXPRESS PLUS Rapid Sample Introduction System Operator’s Manual
Chapter 14: Safety and Regulatory Information
Cleaning Instructions
For additional cleaning information, see “cleaning” in the index.
To clean the exterior surfaces of the instrument, complete the following steps:
1 Shut down and unplug the instrument.
2 Wipe the instrument exterior surfaces only using a towel dampened with a
lab-grade cleaning agent.
3 Repeat step 2, using a towel dampened with clear water.
4 Dry the instrument exterior using a dry towel.
SHOCK HAZARD
Do not allow any liquid to enter the instrument cabinet other than as
intended through the specified tubing, or come into contact with any
electrical components. The instrument must be thoroughly dry before you
reconnect power, or turn the instrument on.
Operating Environment
SHOCK HAZARD
To reduce the risk of fire hazard and electrical shock, do not expose the
unit to rain or humidity. To reduce the risk of electrical shock, do not open
the cabinet. All maintenance is to be performed by an Authorized CETAC
Service Provider.
Protection provided by the equipment may be impaired if the equipment is
used in a manner not specified by the manufacturer.
SHOCK HAZARD
Equipment is not intended for wet locations. Miscellaneous liquids in the
equipment could cause hazardous conditions.
EXPLOSION HAZARD
Do not operate in an explosive atmosphere.
WARNING
WARNING
WARNING
WARNING
To Next Page
Loading...
