ASXPRESS PLUS Rapid Sample Introduction System Operator’s Manual
Chapter 4: Preparing an ASX-260 or ASX-520 Autosampler
51
Verification of Firmware Upgrade
1 Start a terminal emulator program.
2 Enter VERSS. The system should respond with the new firmware version.
Closing Up the Autosampler
Once the firmware has been upgraded and the pump speed has been set, you
can close up the autosampler.
• Reinstall all shields
• Reinstall the front cover
• Reinstall the standards rack
Try to align the standards rack to its original position. Use the marks
left on the rack by the screws as a guide.
• Reinstall the Z-drive assembly
To Next Page
Loading...
