CETAC ASXPRESS PLUS - Installing the 1.0 Mm ID Sample Probe on the Autosampler

ASXPRESS PLUS Rapid Sample Introduction System Operator’s Manual
Chapter 5: Preparing an ASX-1400/1600 Autosampler
61
Installing the 1.0mm ID Sample Probe on the
Autosampler
A 1.0mm ID sample probe is provided for use with the CETAC autosampler for
proper operation with the ASX
PRESS PLUS system. The sample probe/stirrer
holder block must also be replaced, to accommodate the larger sample probe.
You will need the following equipment:
 Sample probe (supplied)
 Holder block (supplied)
 Phillips screwdriver
Figure 5-11 ASX-1400/1600 Z-Drive Assembly
Sample Probe/Stirrer
Holder Block
Sample Probe
Stirrer Motor