CETAC ASXPRESS PLUS - Required Equipment and Supplies

ASXPRESS PLUS Rapid Sample Introduction System Operator’s Manual
Chapter 1: Introduction
13
Optional Accessories/Components
Refer to the ASXPRESS PLUS Rapid Sample Introduction System Accessories and
Supplies Catalog for a full listing of accessories and spare parts.
 Articulating Mounting System. This mounting system allows for stable
and secure, close proximity placement and mounting of the Valve/Pump
Module near the instrument nebulizer.
 Alternate Sample Loops. Alternate sample loop sizes are available as
spares. Available sizes for aqueous applications include:
 0.70 mL
 1.0 mL
 1.25 mL
 1.5 mL
 2.0 mL
 2.5 mL
 3.0 mL
 3.5 mL
 4.0 mL
 4.5 mL
 5.0 mL
Available sizes for oils applications include:
 0.91 mL
 1.02 mL
 1.14 mL
 1.25 mL
 1.36 mL
 1.48 mL.
 2.0 mL
 2.5 mL
 3.0 mL
NOTE
Please refer to the ASXPRESS PLUS Rapid Sample Introduction System Accessories
and Supplies Catalog or contact CETAC Technologies if you need additional
accessories not listed, need added features to integrate the ASXPRESS PLUS
Rapid Sample Introduction System into your analytical system, or have unique
requirements. Research and development of new features and accessories for
the ASXPRESS PLUS Rapid Sample Introduction System, often inspired by
customer requests, is a continuing activity of CETAC Technologies.
Additional Equipment Required
In addition to the provided equipment, you will need:
 A host computer which has been configured with the ICP software. This
computer must have an additional free USB or serial port beyond the ports
required to control the autosampler, spectrometer, and other system
components.