CETAC ASXPRESS PLUS - Page 12

ASXPRESS PLUS Rapid Sample Introduction System Operator’s Manual
Chapter 1: Introduction
12
The following standard components are also shipped with the ASXPRESS PLUS
system:
 Power Supply. A desktop power supply powers the electronics module
and valve/pump module.
 Sample Loops. For aqueous applications, the following standard sized
sample loops are provided: 0.7 mL, 1.00 mL, 1.50 mL, 2.00 mL, 2.50 mL,
3.00 mL, and 4.00 mL. For oils applications, the sample loops provided are:
0.91 mL, 1.02 mL, 1.14 mL, 1.25 mL, 1.36 mL, and 1.48 mL. Additional loops
are available.
 1.0mm Sample Probe. A 1.0mm ID sample probe must be used on the
connected CETAC autosampler to operate properly with the ASX
PRESS PLUS
system. For the ASX-1400 autosampler, a sample probe/stirrer holder block
is supplied to fit the new sample probe.
 Xpress Rinse Station. The Xpress rinse station is specially designed to
accommodate rapid flow of rinse solution through the probe. The Xpress
rinse station will be included in the kit, and must be installed.
 Communication Cables. Two A-B USB cables and two female-female DB-9
RS-232 cables are included.
 ASXpress CD. The CD contains:
 Xpress Configuration Tool software
 C-Term software (terminal program)
 USB device drivers
 Firmware
 This manual
 Quick Installation Guide
 Spare parts catalog
 Other application-specific information
Supplied components depend on the application and autosampler. See the
packing list in the shipping container to see exactly which components are
supplied.