ASXPRESS PLUS Rapid Sample Introduction System Operator’s Manual
Chapter 13: Operating a CETAC Autosampler Using a Terminal Program
ASXPRESS PLUS Commands
The ASXPRESS PLUS Rapid Sample Introduction System can be controlled
through the same serial interface as the autosampler. ASX
PRESS PLUS commands
are prefixed with the “@” symbol.
Command Description
@VER
Returns firmware version.
@SET_PERS-n
Sets the personality (autosampler
compatibility) to n. See the note on the
CD or on www.cetac.com for a list of
personality numbers.
Table 13-2 ASXPRESS PLUS commands
To Next Page
Loading...
