ASXPRESS PLUS Rapid Sample Introduction System Operator’s Manual
Chapter 5: Preparing an ASX-1400/1600 Autosampler
54
INJURY HAZARD
Ensure that AC power to the autosampler is off before proceeding with
installation. If power to the autosampler is not turned off, the autosampler
could begin moving while you are working on it.
The plumbing connections should be made without using tools. Using tools such as
screwdrivers or pliers to perform installation tasks may result in a damaged or
unusable instrument. Do not tighten fittings with anything other than your fingers.
WARNING
CAUTION
To Next Page
Loading...
