ASXPRESS PLUS Rapid Sample Introduction System Operator’s Manual
Chapter 8: Installing the Software
94
The software will read the current configuration and the software controls will
become active. If the software cannot read the parameters, see
"Communications Interface Problems" on page 130.
NOTE
Whenever you start the Xpress Configuration Tool, most of the controls will be
grayed out and inoperable until you click Connect to ASXpress+.
This should be done after the ASXPRESS PLUS system is connected to the
autosampler, and the autosampler is powered on. Clicking the button reads
the parameters that are stored in the electronics module (the default settings
will be read the first time the query is performed), and displays them in the
Configuration Tool parameter fields.
More information regarding use of the Xpress Configuration Tool can be found
in “Configuring the ASXpress Plus System” beginning on page 99.
Figure 8-9 shows the Xpress Config Tool window appearance after connecting.
To Next Page
Loading...
