CG Drives & Automation, 01-5326-01r5 Operation via the Control Panel 85
10.8 Programming example
This example shows how to program a change of the Acc.
Time set from 2.0 s to 4.0 s.
The flashing cursor indicates that a change has taken place
but is not saved yet. If at this moment, the power fails, the
change will not be saved.
Use the ESC, Prev, Next or the Toggle keys to proceed and
to go to other menus.
Fig. 91 Programming example
Menu 100 appears
after power-up.
or
Press “Next” key for
menu [200].
or
Press “Next” key for
menu [300].
or
Press “Enter” key for
menu [310].
or
Press “Next” key two
times for menu [330].
or
Press “Enter” for
menu [331].
or
Press “+” key
Keep “+” key pressed
until desired value has
been reached.
or
Save the changed
value by pressing
“Enter” key.
To Next Page
Loading...
Need help?
General
