Data Analysis
Mode l8500C/8500C+ Operators Manual
7-7
Secti on8.3.8 “Editing Annotation Templates” on pa ge8-8 for a complete description of edit mode.
When you have finished renaming the setup, press the
ENTER
soft key to enter the new name and exit
the edit mode. The name of the setup is updated accordingly on the menu of available setups.
Figure 7-6. Setup Edit Screen
7.3.2.4 Deleting Setups
Spectrum setups may be deleted one at a time or all together. To delete a single setup, first use the
Arrow keys to select a setup in th
SE LSETUP
menu, then press the
CLEAR ONE
soft key. To delete
all the setups stored in memory, press th
CLEAR ALL
soft key.
7.3.2.5 Loading Setups From Disk
Spectrum setups that have been stored to disk may be loaded into 8500C/C+ memory then restored. To
load a Spectrum setup, invoke the
SEL SETUP
selection menu and insert the appropriate disk in th
disk drive. Press
LOAD
to load the setup files from disk. When the load operation is complete, th
menu redisplays along with the new setups. Note that the loading of duplicate setups does not
overwrite existing copies. Duplicate setups are simply added to the menu and sorted accordingly.
7.3.2.6 Storing Setups to Disk
Spectrum setups stored in memory may be stored all at once to disk with the
STORE ALL
soft key.
First invoke the
SEL SETUP
selection menu and insert the appropriate disk in the disk drive. Press
MORE KEYS
, followed by
STORE ALL
. The 8500C/C+ copies all spectrum setups from memory to
disk, regardless of the state of the
STORE TO
field in the Status screen.
7.4 Data Analysis
The spectral data analysis features of the 8500C/C+ allow you to analyze collected vibration data by
manipulating the ways in which the data are displayed. This action is done through the soft keys that
are enabled after a spectral plot has been traced (see Fi gure7-7). Initially, the soft key labels are
hidden. To view them, you must press
SHOW/HIDE
To Next Page
Loading...
Need help?
General
