8-4
Chadwick-Helmuth Company, Inc.
Chapter 8
- Using Printout
Printout Explanation List
The following list explains the call-out notes in Figu re8-1 o n page8-2 an d Figure 8 -2 on page8-3 in
greater detail:
Solution Screen
Printout illustration reproduces for you a copy of the Solution screen
displayed on the 8500C/C+ at the time the solution is generated.
Directions to the User
Gives you brief directions on how to read the printout solution
information, including symbols, terms, and how to make changes.
Basic Chart Information
Gives you the name, part number, and revision date of the current balance
chart.
Tail and Run No.
Tells you the following information:
• Subject aircraft tail number
• Current run number
Date
The date and time the current data was collected.
Azimuth
Shows the azimuth frequency as measured by the magnetic pickup or
Photocell.
Vibration Balance Readings
Gives you all the balance measurements acquired by the 8500C/C+ up to
the point when the current solution was generated. These measurements
are broken down by each channel (as acquired b y each Model7310
Velocimeter) and each regime.
Solution Options
Tells you which solution parameters the 8500C/C+ is taking into account
in calculating your solution.
YES
means the 8500C/C+ is assuming in its
calculations, that you can change the item listed, for example trim tab or
pitch link, in implementing your solution. You may change the solution
options by accessing the Solution Option screen (press
SOLN OPTS
). The
8500C/C+ default is all options set to
YES
.
Iterations and Goals
Establishes the confidence level of the current set of solutions. Iterations
refer to internal calculations within the 8500C/C+. If the Flight Goal
figure is less than the highest in-flight vibration balance reading (see
above), then your current solution is likely to achieve optimum balance
for the aircraft.
Settings
Lists the current weight and trim tab settings for each blade.
FasTrak Trend Screen
Gives you FasTrak trend information. See the FasTrak Operators Manual
for details.
FasTrak Measurements
Gives you track height and lead-lag information, as acquired by th
FasTrak.
8500C/C+ Information
Shows basic 8500C/C+ information, including the current 8500C/C+ and
Mode l8520C Signal Selector firmware version numbers.
To Next Page
Loading...
Need help?
General
