Overview
Chapter 5: Configuring the Internet Connection 97
Chapter 5
This chapter describes how to configure and work with a UTM-1 Internet connection.
This chapter includes the following topics:
Overview....................................................................................................97
Using the Internet Wizard ..........................................................................98
Using Internet Setup.................................................................................113
Setting Up Dialup Modems......................................................................145
Viewing Internet Connection Information................................................152
Enabling/Disabling the Internet Connection.............................................154
Using Quick Internet Connection/Disconnection.....................................155
Configuring a Backup Internet Connection..............................................155
Configuring WAN Load Balancing..........................................................156
Overview
In order to access the Internet through your UTM-1 appliance, you must configure one of
the following connection types:
• Ethernet-based connection
You can configure an Ethernet-based connection in all models. An Ethernet-based
connection can be connected to another network by means of a switch, a router, a
bridge, or an Ethernet-enabled broadband modem.
In ADSL models, the Ethernet-based connection is configured on the DMZ/WAN2
port. In non-ADSL models, you can use the WAN port, the DMZ/WAN2 port, or both
ports for an Ethernet-based Internet connection.
• Direct ADSL connection
You can configure a direct ADSL connection in UTM-1 ADSL models only. These
models include an integrated ADSL modem, which enables you to connect the
appliance directly to your ADSL line without using an additional modem or router.
Configuring the Internet Connection
To Next Page
Loading...
