Check Point UTM-1 Edge - Controlling the Appliance Via the Command Line

Controlling the Appliance via the Command Line
586 Check Point UTM-1 Edge User Guide
In this field… Do this…
Syslog Port Type the port number of the Syslog server.
Default
Click to reset the Syslog Port field to the default (port 514 UDP).
Controlling the Appliance via the Command Line
Depending on your UTM-1 model, you can control your appliance via the command line in
the following ways:
• Using the UTM-1 Portal's command line interface.
See Using the UTM-1 Portal on page
587.
• Using a console connected to the UTM-1 appliance.
For information, see Using the Serial Console on page
589.
• Using an SSH client.
See Configuring SSH on page
595.