Check Point UTM-1 Edge - Configuring High Availability on a Gateway

Configuring High Availability on a Gateway
246 Check Point UTM-1 Edge User Guide
Configuring High Availability on a Gateway
The following procedure explains how to configure HA on a single gateway. You must
perform this procedure on each UTM-1 appliance that you want to include in the HA
cluster.
To configure HA on a UTM-1 appliance
1. Set the appliance’s internal IP addresses and network range.
Each appliance must have a different internal IP address.
See Changing IP Addresses on page
162.
2. Click Setup in the main menu, and click the High Availability tab.
The High Availability page appears.
3. Select the Gateway High Availability check box.