Check Point UTM-1 Edge - Configuring Smartdefense

Configuring SmartDefense
376 Check Point UTM-1 Edge User Guide
Configuring SmartDefense
You can configure SmartDefense using the following tools:
• SmartDefense Wizard. Resets all SmartDefense settings to their defaults, and then
creates a SmartDefense security policy according to your network and security
preferences. See Using the SmartDefense Wizard on page
376.
• SmartDefense Tree. Enables you to fine tune individual settings in the
SmartDefense policy. You can use the SmartDefense tree instead of, or in
addition to, the wizard. See Using the SmartDefense Tree on page
381.
Using the SmartDefense Wizard
The SmartDefense Wizard allows you to configure your SmartDefense security policy
quickly and easily through its user-friendly interface.
Note: The SmartDefense wizard clears any existing SmartDefense settings.
After using the wizard, you can fine tune the policy settings using the SmartDefense tree.
See Using the SmartDefense Tree on page
381.
To configure the SmartDefense policy using the wizard
1. Click Security in the main menu, and click the SmartDefense tab.