Check Point UTM-1 Edge - Installing and Setting Up UTM-1

Before You Install the UTM-1 Appliance
Chapter 3: Installing and Setting Up UTM-1 53
Chapter 3
This chapter describes how to properly set up and install your UTM-1 appliance in your
networking environment.
This chapter includes the following topics:
Before You Install the UTM-1 Appliance..................................................53
UTM-1 Edge X and UTM-1 Edge W Installation......................................67
Cascading Your Appliance.........................................................................82
Connecting the Appliance to Network Printers..........................................83
Setting Up the UTM-1 Appliance ..............................................................83
Before You Install the UTM-1 Appliance
Prior to connecting and setting up your UTM-1 appliance for operation, you must do the
following:
• Check if TCP/IP Protocol is installed on your computer.
• Check your computer’s TCP/IP settings to make sure it obtains its IP address
automatically.
Refer to the relevant section in this guide in accordance with the operating system that runs
on your computer. The sections below will guide you through the TCP/IP setup and
installation process.
Installing and Setting Up UTM-1