Check Point UTM-1 Edge - Updating the Firmware

Workflow
566 Check Point UTM-1 Edge User Guide
Workflow
To use Remote Desktop
1. Configure Remote Desktop.
See Configuring Remote Desktop on page
567.
2. Enable the Remote Desktop server on computers that authorized users should
be allowed to remotely access.
See Configuring the Host Computer on page
570.
3. Grant Remote Desktop Access permissions to users who should be allowed to
remotely access desktops.
See Adding and Editing Users on page
546.
4. The authorized users can access remote computers' desktops as desired.
See Accessing a Remote Computer's Desktop on page
573.