Logging on to a Remote Access VPN Site
524 Check Point UTM-1 Edge User Guide
3. To disable a VPN site, do the following:
Note: Disabling a VPN site eliminates the tunnel and erases the network topology.
a. Click the icon in the desired VPN site’s row.
A confirmation message appears.
b. Click OK.
The icon changes to
, and the VPN site is disabled.
Logging on to a Remote Access VPN Site
You need to manually log on to Remote Access VPN Servers configured for Manual
Login. You do not need to manually log on to a Remote Access VPN Server configured for
Automatic Login or a Site-to-Site VPN Gateway: all the computers on your network have
constant access to it.
Manual Login can be done through either the UTM-1 Portal or the my.vpn page. When
you log on and traffic is sent to the VPN site, a VPN tunnel is established. Only the
computer from which you logged on can use the tunnel. To share the tunnel with other
computers in your home network, you must log on to the VPN site from those computers,
using the same user name and password.
Note: You must use a single user name and password for each VPN destination
gateway.
To Next Page
Loading...
