UTM-1 Edge X and UTM-1 Edge W Installation
Chapter 3: Installing and Setting Up UTM-1 67
UTM-1 Edge X and UTM-1 Edge W Installation
Installing UTM-1 Edge X and Edge W
To install the UTM-1 appliance
1. Verify that you have the correct cable type.
For information, see Network Requirements on page
30.
2. Connect the LAN cable:
a. Connect one end of the Ethernet cable to one of the appliance's LAN
ports.
b. Connect the other end to PCs, hubs, or other network devices.
3. Connect the WAN cable:
a. Connect one end of the Ethernet cable to the appliance's WAN port.
b. Connect the other end of the cable to a cable modem, DSL modem, or
office network.
4. Connect the power supply to the appliance's power socket, labeled PWR.
5. Plug the power supply into the wall electrical outlet.
Warning: The UTM-1 appliance power supply is compatible with either 100, 120 or
230 VAC input power. Verify that the wall outlet voltage is compatible with the
voltage specified on your power supply. Failure to observe this warning may result
in injuries or damage to equipment.
To Next Page
Loading...
