Configuring Computers to Use Network Printers
632 Check Point UTM-1 Edge User Guide
7. To change the port number, do the following:
a. Type the desired port number in the Printer Server TCP Port field.
Note: Printer port numbers may not overlap, and must be high ports.
b. Click Apply.
You may want to change the port number if, for example, the printer you are setting
up is intended to replace another printer. In this case, you should change the
replacement printer's port number to the old printer's port number, and you can skip
the next step.
8. Configure each computer from which you want to enable printing to the
network printer.
See Configuring Computers to Use Network Printers on page
632.
Configuring Computers to Use Network Printers
Perform the relevant procedure on each computer from which you want to enable printing
via the UTM-1 print server to a network printer.
Windows Vista
This procedure is relevant for computers with a Windows Vista operating system.
To configure a computer to use a network printer
1. If the computer for which you want to enable printing is located on the WAN,
create an Allow rule for connections from the computer to This Gateway.
See Adding and Editing Rules on page
338.
2. Click Start > Control Panel.
To Next Page
Loading...
