Overview
Chapter 10: Working with Wireless Networks 269
You can configure up to seven WDS links, in addition to the primary WLAN. For
information on configuring WDS links, see Configuring WDS Links on page
298.
Note: All access points in a WDS must use the same radio channel for the WDS link
and for communicating with wireless stations. Therefore, using WDS may have a
negative impact on wireless throughput. In this case, it is recommended to use a
traditional wired backbone to connect the access points, instead of WDS links.
Figure 28: Redundant Loop of Access Points Linked by WDS and STP
To Next Page
Loading...
