Check Point UTM-1 Edge - Page 337

Viewing the Routing Table
Chapter 11: Viewing Reports 323
Table 58: Routing Table Fields
This field… Displays…
Source The route's source
Destination The route's destination
Service The network service for which the route is configured
Gateway The gateway's IP address
Metric The route's metric
Interface The interface for which the route is configured
Origin The route's type:
• Connected Route. A route to a network that is directly connected
to the UTM-1 appliance
• Static Route. A destination-based or service-based static route.
See Using Static Routes on page
202.
• Dynamic Route. A route obtained through a dynamic routing
protocol, such as OSPF
• Source Route. A source-based static route. See Using Static
Routes on page
202.