Check Point UTM-1 Edge - Page 450

Configuring VStream Antivirus
436 Check Point UTM-1 Edge User Guide
11. Click Finish.
The new rule appears in the Antivirus Policy page.
Table 99: VStream Antivirus Rule Fields
In this field… Do this…
Any Service Click this option to specify that the rule should apply to any service.
Standard
Service
Click this option to specify that the rule should apply to a specific standard
service or network service object.
You must then select the desired service or network service object from the
drop-down list.
Custom Service Click this option to specify that the rule should apply to a specific non-
standard service.
The Protocol and Port Range fields are enabled. You must fill them in.
Protocol Select the protocol (TCP, UDP, or ANY) for which the rule should apply.
Port Range To specify the port range to which the rule applies, type the start port
number in the left text box, and the end port number in the right text box.
Note: If you do not enter a port range, the rule will apply to all ports. If you
enter only one port number, the range will include only that port.
If the
connection
source is
Select the source of the connections you want to allow/block.
To specify an IP address, select Specified IP and type the desired IP address
in the field provided.
To specify an IP address range, select Specified Range and type the desired
IP address range in the fields provided.