Resetting the UTM-1 Appliance to Defaults
624 Check Point UTM-1 Edge User Guide
Warning: This operation erases all your settings and password information. You will
have to set a new password and reconfigure your UTM-1 appliance for Internet
connection. For information on performing these tasks, see Setting Up the UTM-1
Appliance on page
83.
This operation also resets your appliance to its default Product Key. Therefore, if you
upgraded your license, you should save your Product Key before resetting to defaults.
You can view the installed Product Key by in the UTM-1 Licensing Wizard. For
information on accessing this wizard, see Upgrading Your License on page
582.
You can reset the UTM-1 appliance to defaults via the Web management interface
(software) or by manually pressing the Reset button (hardware) located at the back of the
UTM-1 appliance.
When resetting the appliance via the UTM-1 Portal, you can choose to keep the current
firmware or to revert to the firmware version that shipped with the UTM-1 appliance. In
contrast, using the Reset button automatically reverts the firmware version.
To reset the UTM-1 appliance to factory defaults via the Web interface
1. Click Setup in the main menu, and click the Tools tab.
The Tools page appears.
2. Click Factory Settings.
To Next Page
Loading...
