CIM ME2000S - Page 122

9 - DIAGNOSTICS
DIAGNOSTICA (ME)
ME2000S - User Manual
122 - 133
CODE MESSAGE DESCRIPTION SOLUTION
10 Motor x (Generic)
X motor driver error
Turn o󰀨 the machine and wait a few
seconds. Verify if a plate remains
jammed. Start and re-initialize the
machine. If the error still occurs,
contact Service Support.
11 Motor x (Driver generic)
12 Motor x (Driver high Z)
13 Motor x (Driver busy)
X motor driver error
Turn o󰀨 the machine and wait a few
seconds. Verify if a plate remains
jammed. Start and re-initialize the
machine. If the error still occurs,
contact Service Support.
14 Motor x (Driver direction)
15 Motor x (Driver status)
16 Motor x (Driver command)
17 Motor x (Driver step mode)
18 Motor x (Driver under-voltage)
19
Motor x (Driver under-voltage
ADC)
20 Motor x (Driver over-current)
21 Motor x (Driver thermal)
22
Motor x (Zero: First zero active
not detected)
Error during the reset of axis X
Check the “X-motor” sensor and/or
switch o󰀨 the machine and check the
motor movement. If the error is still
present, contact technical support.
23
Motor x (Zero: Zero not active not
detected)
24
Motor x (Zero: Second zero active
not detected)
25
Motor x (Zero: First zero not active
not detected)
26
Motor x (Zero: Di󰀨erence in steps
is too high)