CIM ME2000S - Page 130

9 - DIAGNOSTICS
DIAGNOSTICA (ME)
ME2000S - User Manual
130 - 133
CODE MESSAGE DESCRIPTION SOLUTION
135
Zero: First zero not active not
detected
generic driver motor error
Turn o󰀨 the machine and wait a few
seconds. Verify if a plate remains
jammed. Start and re-initialize the
machine. If the error still occurs,
contact Service Support.
136
Zero: Di󰀨erence in steps is too
high
137 Zero: Motor busy Internal error
Turn o󰀨 the machine and wait a few
seconds. Verify if a plate remains
jammed. Start and re-initialize the
machine. If the error still occurs,
contact Service Support.
138 Internal error pipe communication error
Turn off the machine and wait
some seconds. Start and reset the
machine. If error persists contact
Technical Assistance.
139 Internal error ping Ping command error
140 Command not managed Software internal error