2-114 Cisco 7000 Hardware Installation and Maintenance
Site Log
FDDI interface cables, 1 or 2 multimode, 2 or 4 single-mode for each FIP
HSSI interface cable, 1 per port required
Null modem cable for back-to-back HSSI connections
MIP cables, 1 per port required
AIP cables and types, 1 per AIP port required
Other optional equipment Ethernet/Fast Ethernet transceiver or 802.3 attachment unit
MAU, CSU/DSU for network connections
Flash memory card
Documentation Cisco 7000 User Guide and UniverCD (ship with chassis), and any printed documentation as
ordered
System components: Processor slots 5 and 6 should contain an SP (or SSP) and RP, or an RSP7000 (slot 5) and an
RSP7000CI (slot 6), and any combination of 5 interface processors or blank interface processor
fillers
RP Installed in the RP slot (rightmost slot)
SP Installed in SP slot instead of SSP (immediately left of the RP)
SSP Installed in SSP slot instead of SP (immediately left of the RP)
RSP7000 Installs in the SP (or SSP) slot (slot 5) instead of the SP (or SSP). Used with the RSP7000CI.
RSP7000CI Installs in the RP slot (slot 6) instead of the RP. Used with the RSP7000.
AIPs Enter slot locations and port addresses on Configuration Worksheet
CIPs Enter slot locations and port addresses on Configuration Worksheet
EIPs Enter slot locations and port addresses on Configuration Worksheet
FEIPs Enter slot locations and port addresses on Configuration Worksheet
TRIPs Enter slot locations and port addresses on Configuration Worksheet
FIPs Enter slot locations and port addresses on Configuration Worksheet
FSIPs Enter slot locations and port addresses on Configuration Worksheet
HIPs Enter slot locations and port addresses on Configuration Worksheet
MIPs Enter slot locations and port addresses on Configuration Worksheet
Other optional equipment:
Component Description Rec’d
To Next Page
Loading...
Need help?
General
