Preparing for Installation 2-89
Preparing Network Connections
For multimode SONET connections, connect the multimode cable to the SC connector on the PLIM.
(See Figure 2-10.)
Figure 2-10 SONET Multimode SC Duplex PLIM
The SONET multimode SC-duplex connector is shipped with a dust plug. (See Figure 2-11.)
Remove the plug by pulling on the plug as you squeeze the sides of the connector.
Figure 2-11 SONET ATM Multimode Fiber-Optic Transceiver and Dust Plug
For single-mode SONET connections, connect the single-mode cable to the ST connector on the
SONET PLIM. (See Figure 2-12.)
Figure 2-12 SONET Single-Mode PLIM
H2210
H1983
H2212
To Next Page
Loading...
