Index
IN-12
Catalyst 4500 Series Switch Cisco IOS Software Configuration Guide
OL-23818-01
configuring Layer 2 24-10
configuring Layer 3 24-6
displaying to a virtual switch system 24-16
interface port-channel command 24-7
lacp system-priority
command example
24-13
modes 24-3
overview 24-2
PAgP
Understanding
24-3
physical interface configuration 24-7
port-channel interfaces 24-2
port-channel load-balance command 24-14
removing 24-15
removing interfaces 24-15
EtherChannel guard
disabling
23-6
enabling 23-6
overview 23-6
Ethernet management port
and routing
7-6
and routing protocols 7-6
configuring 7-10
default setting 7-6
described 1-26, 7-6
for network management 1-26, 7-6
specifying 7-10
supported features 7-9
unsupported features 7-10
Ethernet management port, internal
and routing protocols
7-6
Ethernet Management Port, using 7-6
Ethernet OAM 63-34
and CFM interaction 63-51
configuration guidelines 63-35
configuring with CFM 63-51
default configuration 63-35
discovery 63-34
enabling 63-36, 63-52
link monitoring 63-34, 63-38
messages 63-34
protocol
defined
63-33
monitoring 63-49
remote failure indications 63-34
remote loopback 63-34, 63-37
templates 63-45
Ethernet OAM protocol CFM notifications 63-51
Ethernet Remote Defect Indication (ETH-RDI) 63-28
event triggers, user-defined
configuring, 802.1X-based
19-8
configuring, MAC address-based 19-9
explicit host tracking
enabling
25-11
extended range VLANs
See VLANs
Extensible Authentication Protocol over LAN
44-2
Exterior Gateway Protocol
See EGP
F
Fa0 port
See Ethernet management port
Failure detection, using BFD
37-6
Fallback Authentication
configure with 802.1X
44-73
FastDrop
overview
35-10
fastethernet0 port
See Ethernet management port
Fast UDLD
configuring probe message interval
30-8
default configuration 30-4
displaying link status 30-9
enabling globally 30-5
enabling on individual interface 30-7
To Next Page
Loading...
