Cisco Catalyst 4500 Series - Page 1579

Index
IN-13
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-23818-01
enabling per-interface 30-6
modes of operation 30-3
resetting disabled LAN interfaces 30-8
use case 30-2
Fast UDLD, overview 30-1
feature interactions, Wireshark 56-6
FIB
description
33-2
See also MFIB
fiber-optics interfaces
disabling UDLD
30-7
Filter-ID ACL and Per-User ACL, configureport-based
authentication
configure Per-User ACL and Filter-ID ACL
44-44
filtering
in a VLAN
51-17
non-IP traffic 51-14, 51-15
filters, Wireshark 56-3
flags 35-11
Flash memory
configuring router to boot from
3-31
loading system images from 3-30
security precautions 3-31
Flexible NetFlow
caveats
62-1
defined 1-4, 62-1
Flex Links
configuration guidelines
21-6
configuring 21-6, 21-7
configuring preferred VLAN 21-9
configuring VLAN load balancing 21-8
monitoring 21-12
flooded traffic, blocking 53-2
flowchart, traffic marking procedure 40-20
flow control, configuring 7-22
For 13-13
forward-delay time (STP)
configuring
20-19
forwarding information base
See FIB
frame command
71-5
G
gateway
See default gateway
get-bulk-request operation
60-3
get-next-request operation 60-3, 60-4
get-request operation 60-3, 60-4
get-response operation 60-3
Gigabit Ethernet SFP ports
deploy with 10-Gigabit Ethernet
7-12, 7-13
global configuration mode 2-5
Guest-VLANs
configure with 802.1X
44-55
H
hardware and software ACL support 51-6
hardware switching 33-5
hello time (STP)
configuring
20-17
high CPU due to ACLs, troubleshooting 51-6
history
CLI
2-4
history table, level and number of syslog messages 58-9
hop counts
configuring MST bridges
20-28
host
limit on dynamic port
15-29
host modes, MACsec 43-4
host ports
kinds of
42-4
host presence CDP message 44-8
Hot Standby Routing Protocol
See HSRP
HSRP
description
1-13