Index
IN-16
Catalyst 4500 Series Switch Cisco IOS Software Configuration Guide
OL-23818-01
Universal Power over Ethernet 1-29
Web-based Authentication 1-38
Web Content Coordination Protocol 1-29
Wireshark 1-30
XML-PI 1-30
Intrusion Detection System
See IDS
inventory management TLV
29-3, 29-9
IOS shell
See Auto SmartPorts macros
IP
configuring default gateway
3-11
configuring static routes 3-11
displaying statistics 33-8
IP addresses
128-bit
52-2
cluster candidate or member 14-12
cluster command switch 14-11
discovering 4-37
IPv6 52-2
ip cef command 33-6, 68-2
IP Enhanced IGRP
interfaces, displaying
32-19
ip icmp rate-limit unreachable command 8-13
ip igmp profile command 25-21
ip igmp snooping tcn flood command 25-13
ip igmp snooping tcn flood query count command 25-14
ip igmp snooping tcn query solicit command 25-14
IP information
assigned
through DHCP-based autoconfiguration
3-2
ip load-sharing per-destination command 33-7
ip local policy route-map command 38-7
ip mask-reply command 8-14
IP MTU sizes,configuring 32-9
IP multicast
clearing table entries
35-27
configuring 35-12
default configuration 35-13
displaying PIM information 35-23
displaying the routing table information 35-23
enabling dense-mode PIM 35-14
enabling sparse-mode 35-14
features not supported 35-12
hardware forwarding 35-8
IGMP snooping and 25-5, 35-4
overview 35-1
routing protocols 35-2
software forwarding 35-8
See also Auto-RP; IGMP; PIM; RP; RPF
IP multicast routing
enabling
35-13
monitoring and maintaining 35-22
ip multicast-routing command 35-13
IP multicast traffic, load splitting 35-21
IP phones
configuring voice ports
41-3
See Cisco IP Phones 41-1
ip pim command 35-14
ip pim dense-mode command 35-14
ip pim sparse-dense-mode command 35-15, 35-16
ip policy route-map command 38-7
IP Port Security for Static Hosts
on a Layer 2 access port
50-25
on a PVLAN host port 50-28
overview 50-24
ip redirects command 8-14
IP routing tables
deleting entries
35-27
IP Service Level Agreements
See IP SLAs
IP service levels, analyzing
66-1
IP SLAs
benefits
66-2
CFM endpoint discovery 63-21
configuration guidelines 66-6
Control Protocol 66-4
default configuration 66-6