Cisco Catalyst 4500 Series - Page 1585

Index
IN-19
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-23818-01
Layer 3 interface counters,understanding 32-3
Layer 3 interfaces
changing from Layer 2 mode
39-7
configuration guidelines 32-5
configuring VLANs as interfaces 32-7
overview 32-1
counters 32-3
logical 32-2
physical 32-2
SVI autostate exclude 32-3
Layer 3 packets
classification methods
40-2
Layer 4 port operations
configuration guidelines
51-11
restrictions 51-10
Leave timer, enabling 25-9
limitations on using a TwinGig Convertor 7-14
link and trunk status events
configuring interface
7-36
link integrity, verifying with REP 22-4
Link Layer Discovery Protocol
See CDP
link monitoring, Ethernet OAM
63-34, 63-38
link-state tracking
configuration guidelines
24-21
default configuration 24-21
described 24-18
displaying status 24-22
generic configuration procedure 24-21
link status, displaying UDLD 30-9
listening state (STP)
RSTP comparisons (table)
20-24
LLDP
configuring
29-4
characteristics 29-5
default configuration 29-5
disabling and enabling
globally
29-6
on an interface 29-7
monitoring and maintaining 29-14
overview 29-1
transmission timer and holdtime, setting 29-5
LLDP-MED
configuring
procedures
29-4
TLVs 29-9, 29-11
monitoring and maintaining 29-14
overview 29-1
supported TLVs 29-2
LLDP Media Endpoint Discovery
See LLDP-MED
load balancing
configuring for CEF
33-7
configuring for EtherChannel 24-14
overview 24-5, 33-6
per-destination 33-7
load splitting IP multicast traffic 35-21
Location Service
overview
29-1
location service
configuring
29-12
understanding 29-3
location TLV 29-3, 29-9
logging, EPM 44-117
Logical Layer 3 interfaces
configuring
32-6
logical layer 3 VLAN interfaces 32-2
login authentication
with RADIUS
44-103
with TACACS+ 3-19
login banners 4-17
login timer
changing
8-7
logoutwarning command 8-7
loop guard
and MST
20-23
configuring 23-4
overview 23-3