Cisco Catalyst 4500 Series - Page 1584

Index
IN-18
Catalyst 4500 Series Switch Cisco IOS Software Configuration Guide
OL-23818-01
SNMP support 5-15, 6-14
SSO overview 5-3, 6-3
versioning capability in software to support 5-13
IST
and MST regions
20-22
description 20-22
master 20-27
ITU-T Y.1731
See Y.1731
J
jumbo frames
and ethernet ports
7-26
configuring MTU sizes for 7-27
ports and linecards that support 7-24
understanding MTUs 7-25
understanding support 7-25
VLAN interfaces 7-26
K
keyboard shortcuts 2-3
L
l2protocol-tunnel command 27-17
labels, definition 40-3
LACP
system ID
24-4
Layer 2 access ports 17-7
Layer 2 Control Packet QoS
and CoPP configuration example
48-14
default configuation 48-11
disabling 48-13
enabvling 48-12
guideline and restrictions 48-16
understanding 48-11
Layer 2 frames
classification with CoS
40-2
Layer 2 interface
applying ACLs
51-31
configuring access-mode mode on 51-31
configuring IPv4, IPv6, and MAC ACLs 51-29
displaying an ACL configuration 51-32
Layer 2 interfaces
assigning VLANs
15-7
configuring 17-5
configuring as PVLAN host ports 42-18
configuring as PVLAN promiscuous ports 42-17
configuring as PVLAN trunk ports 42-19
defaults 17-4
disabling configuration 17-8
modes 17-3
show interfaces command 17-6
Layer 2 interface type
resetting
42-24
setting 42-24
Layer 2 protocol tunneling
default configuration
27-16
guidelines 27-16
Layer 2 switching
overview
17-1
Layer 2 Traceroute
and ARP
8-11
and CDP 8-11
host-to-host paths 8-11
IP addresses and subnets 8-11
MAC addresses and VLANs 8-11
multicast traffic 8-11
multiple devices on a port 8-11
unicast traffic 1-37, 8-10
usage guidelines 8-11
Layer 2 trunks
configuring
17-5
overview 17-3
Layer 3 interface, applying IPv6 ACLs 51-17
Layer 3 interface counters,configuring 32-10