Index
IN-25
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-23818-01
configuration (example) 38-8
enabling 38-6
features 38-2
overview 38-1
route-map processing logic 38-3
route-map processing logic example 38-4
route maps 38-2
when to use 38-5
percentage thresholds in tracked lists 57-6
per-port and VLAN Access Control List 50-19
per-port per-VLAN QoS
enabling
40-35
overview 40-10
Per-User ACL and Filter-ID ACL, configure 44-44
Per-VLAN Rapid Spanning Tree 20-6
enabling 20-20
overview 20-6
PE to CE routing, configuring 39-12
physical layer 3 interfaces 32-2
Physical Layer 3 interfaces, configuring 32-12
PIM
configuring dense mode
35-14
configuring sparse mode 35-14
displaying information 35-23
displaying statistics 35-27
enabling sparse-dense mode 35-14, 35-15
overview 35-3
PIM-DM 35-3
PIM on an interface, enabling 35-14
PIM-SM 35-3
PIM-SSM mapping, enabling 35-16
ping
executing
8-9
overview 8-8
ping command 8-9, 35-23
PoE 13-7, 13-8
configuring power consumption, powered
devices
13-5
configuring power consumption for single
device
13-5, 13-16
displaying operational status for an interface 13-6
Enhanced PoE support on E-series 13-15
policing and monitoring 13-12
power consumption for powered devices
Intelligent Power Management
13-4
powering down a module 12-19
power management modes 13-2
PoE policing
configuring errdisable recovery
13-14
configuring on an interface 13-13
displaying on an interface 13-14
power modes 13-12
point-to-point
in 802.1X authentication (figure)
44-3
policing
how to implement
40-17
See QoS policing
policing, PoE
13-12
policing IPv6 control traffic 48-16
policy associations, QoS on Sup 6-E 40-38
policy-map command 40-15
policy map marking action, configuring 40-22
port ACLs
and voice VLAN
51-4
defined 51-3
Port Aggregation Protocol
see PAgP
port-based authentication
802.1X with voice VLAN
44-22
Authentication Failed VLAN assignment 44-17
authentication server
defined
46-2
changing the quiet period 44-81
client, defined 44-3, 46-2
configuration guidelines 44-28, 46-6
configure ACL assignments and redirect URLs 44-38
To Next Page
Loading...
