Cisco Catalyst 4500 Series - Page 1596

Index
IN-30
Catalyst 4500 Series Switch Cisco IOS Software Configuration Guide
OL-23818-01
parameters on the switch 44-32
RA Guard
configuring
51-36
deployment 51-36
examples 51-37
introduction 51-35
usage guidelines 51-38
range command 7-4
range macros
defining
7-10
ranges of interfaces
configuring
7-4
Rapid Spanning Tree
See RSTP
rcommand command
14-13
reachability, tracking IP SLAs IP host 57-9
re-authentication of a client
configuring manual
44-91
enabling periodic 44-78
redirect URLs, port-based authentication 44-20
reduced MAC address 20-2
redundancy
configuring
9-7, 10-7
guidelines and restrictions 9-5, 10-5
changes made through SNMP 9-11, 10-11
NSF-aware support 11-2
NSF-capable support 11-2
overview 9-2, 10-2
redundancy command 9-8, 10-7
understanding synchronization 9-4, 10-5
redundancy (NSF) 11-1
configuring
BGP
11-11
CEF 11-10
EIGRP 11-16
IS-IS 11-13
OSPF 11-12
routing protocols 11-5
redundancy (RPR)
route processor redundancy
9-2, 10-3
synchronization 9-5, 10-5
redundancy (SSO)
redundancy command
11-10
route processor redundancy 9-3, 10-3
synchronization 9-5, 10-5
reload command 3-28, 3-29
Remote Authentication Dial-In User Service
See RADIUS
remote failure indications
63-34
remote loopback, Ethernet OAM 63-34, 63-37
Remote Network Monitoring
See RMON
rendezvous point, configuring
35-16
rendezvous point, configuring single static 35-20
REP
administrative VLAN
22-8
administrative VLAN, configuring 22-9
and STP 22-6
configuration guidelines 22-7
configuring interfaces 22-10
convergence 22-4
default configuration 22-7
manual preemption, configuring 22-13
monitoring 22-14
neighbor offset numbers 22-5
open segment 22-2
ports 22-6
preempt delay time 22-5
primary edge port 22-4
ring segment 22-2
secondary edge port 22-4
segments 22-1
characteristics 22-2
SNMP traps, configuring 22-14
supported interfaces 22-1
triggering VLAN load balancing 22-6
verifying link integrity 22-4
VLAN blocking 22-13