Cisco Catalyst 4500 Series - Page 1597

Index
IN-31
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-23818-01
VLAN load balancing 22-4
replication
description
35-9
report suppression, IGMP
disabling
26-10
reserved-range VLANs
See VLANs
reset command
71-3
resetting an interface to default configuration 7-38
resetting a switch to defaults 3-32
Resilient Ethernet ProtocolLSee REP
responder, IP SLAs
described
66-4
enabling 66-7
response time, measuring with IP SLAs 66-4
restricting access
NTP services
4-8
RADIUS 44-92
TACACS+ 3-15
retransmission number
setting in 802.1X authentication
44-83
retransmission time
changing in 802.1X authentication
44-82
RFC
1157, SNMPv1
60-2
1305, NTP 4-2
1757, RMON 67-2
1901, SNMPv2C 60-2
1902 to 1907, SNMPv2 60-2
2273-2275, SNMPv3 60-2
RFC 5176 Compliance 44-95
RIP
description
1-16
for IPv6 52-5
RMON
default configuration
67-3
displaying status 67-6
enabling alarms and events 67-3
groups supported 67-2
overview 67-1
ROM monitor
boot process and
3-26
CLI 2-7
commands 71-2 to 71-3
debug commands 71-5
entering 71-1
exiting 71-6
overview 71-1
root bridge
configuring
20-10
selecting in MST 20-22
root guard
and MST
20-23
enabling 23-2
overview 23-2
routed packets
ACLs
51-26
route-map (IP) command 38-6
route maps
defining
38-6
PBR 38-2
router ACLs
description
1-36, 51-3
using with VLAN maps 51-25
router ACLs, using PACL with VLAN maps 51-32
route targets
VPN
39-3
Routing Information Protocol
See RIP
RPF
<Emphasis>See Unicast RPF
RSPAN
configuration guidelines
55-16
destination ports 55-5
IDS 55-2
monitored ports 55-4
monitoring ports 55-5
received traffic 55-3