Cisco Catalyst 4500 Series - Page 24

Contents
xxii
Software Configuration Guide—Release IOS XE 3.3.0SG and IOS 15.1(1)SG
OL-25340-01
Displaying IGMP Filtering Configuration 25-24
CHAPTER 26 Configuring IPv6 MLD Snooping 26-1
About MLD Snooping 26-1
MLD Messages 26-2
MLD Queries 26-3
Multicast Client Aging 26-3
Multicast Router Discovery 26-3
MLD Reports 26-4
MLD Done Messages and Immediate-Leave 26-4
Topology Change Notification Processing 26-4
Configuring IPv6 MLD Snooping 26-5
Default MLD Snooping Configuration 26-5
MLD Snooping Configuration Guidelines 26-6
Enabling or Disabling MLD Snooping 26-6
Configuring a Static Multicast Group 26-7
Configuring a Multicast Router Port 26-7
Enabling MLD Immediate Leave 26-8
Configuring MLD Snooping Queries 26-9
Disabling MLD Listener Message Suppression 26-10
Displaying MLD Snooping Information 26-10
CHAPTER 27 Configuring 802.1Q Tunneling, VLAN Mapping, and Layer 2 Protocol Tunneling 27-1
About 802.1Q Tunneling 27-2
Configuring 802.1Q Tunneling 27-3
802.1Q Tunneling Configuration Guidelines 27-3
Native VLANs 27-4
System MTU 27-5
802.1Q Tunneling and Other Features 27-5
Configuring an 802.1Q Tunneling Port 27-6
About VLAN Mapping 27-7
Deployment Example 27-7
Mapping Customer VLANs to Service-Provider VLANs 27-9
Configuring VLAN Mapping 27-9
Default VLAN Mapping Configuration 27-9
VLAN Mapping Configuration Guidelines 27-10
Configuring VLAN Mapping 27-11
One-to-One Mapping 27-11
Traditional Q-in-Q on a Trunk Port 27-12